I have a BRS system. I just changed the DI media (BRS media) and I'm getting the same TDS in as out. .008 I thought I might have over packed it so I took some out and loosed up the media also made sure sponge filter was clean, but still getting the same TDS. Almost seems as flow is bypassing media. System normally works great.
-
Folks, if you've recently upgraded or renewed your annual club membership but it's still not active, please reach out to the BOD or a moderator. The PayPal system has a slight bug which it doesn't allow it to activate the account on it's own.
DI problem
- Thread starter Mark...
- Start date
You actually want to tight pack DI resin so you don't get flow passing the media.
What TDS meter do you have? If you have the in-line type, switch them around to make sure your down line reader isn't toast. Just a thought.....otherwise, I'm scratching my head.
What TDS meter do you have? If you have the in-line type, switch them around to make sure your down line reader isn't toast. Just a thought.....otherwise, I'm scratching my head.
It has the TDS meter built into the DI on top of the canister. Didn't touch tubing or wires, just the container. Very strange. The flow into the brute seems very strong compared to the normal slower steady flow.
I'll try that...in the past if I changed the media it dropped to .000 right away. But
i'll give it a go. Thanks everyone,
Well tell us so the rest of us idiots don't do it as well!
This is embarrassing... I put the canister in upside down...
Oh yeah!