Hey folks.
I have a chance to pick up a great looking Oceanic cube with stand, but theres a potential problem.
The tank has 3 chips on one corner, worried about structural integrity.
Top pic shows the chips. The two bottom ones are insignificant.
The top one concerns me. The chip seems to be going through the glass down to the silicon.
I'm unsure if this is the case or if its a glass refraction thing, but, regardless, the crack does extend into the seam to some extent.
Bottom shot shows inside seal. Seems tight, owner tells me it holds water fine.
Is the chip a concern? If so, can it be sealed with epoxy or superglue or such?
Never dealt with a cracked tank, so experience is at zero on this one (and most other things in life).
I have a chance to pick up a great looking Oceanic cube with stand, but theres a potential problem.
The tank has 3 chips on one corner, worried about structural integrity.
Top pic shows the chips. The two bottom ones are insignificant.
The top one concerns me. The chip seems to be going through the glass down to the silicon.
I'm unsure if this is the case or if its a glass refraction thing, but, regardless, the crack does extend into the seam to some extent.
Bottom shot shows inside seal. Seems tight, owner tells me it holds water fine.
Is the chip a concern? If so, can it be sealed with epoxy or superglue or such?
Never dealt with a cracked tank, so experience is at zero on this one (and most other things in life).