-
Folks, if you've recently upgraded or renewed your annual club membership but it's still not active, please reach out to the BOD or a moderator. The PayPal system has a slight bug which it doesn't allow it to activate the account on it's own.
weldon #16 and Craftic #33
- Thread starter Olivier
- Start date
I was looking for some as well, but the only luck I had was finding some places online that would ship to me.
only take about 1 week to get to NJ. I need it like 2 days 
. i will call www.njplastics.com and see what happens. they might carry some and willing to sell it.
. i will call www.njplastics.com and see what happens. they might carry some and willing to sell it.
radiata
NJRC Member
Olivier,
Somewhere north of Route 46, before it branches into 3 and 46, there's a plastic fabricating shop where I bought some Weld-On #16, maybe two years ago. I can't remember the name of the place or exactly where it is (Great Notch?). I tried to find it again last month but failed. I've got a half a tube left - you can have it if you're willing to drive to Livingston for it.
Regards,
Bob
Somewhere north of Route 46, before it branches into 3 and 46, there's a plastic fabricating shop where I bought some Weld-On #16, maybe two years ago. I can't remember the name of the place or exactly where it is (Great Notch?). I tried to find it again last month but failed. I've got a half a tube left - you can have it if you're willing to drive to Livingston for it.
Regards,
Bob
It's called Acme Plastics.
http://www.acmeplastics.com/locations.html
Also McMaster Carr carries it and ships. They're in NJ so it doesn't take long to get it.
http://www.mcmaster.com
http://www.acmeplastics.com/locations.html
Also McMaster Carr carries it and ships. They're in NJ so it doesn't take long to get it.
http://www.mcmaster.com
Jcurry@wesketch said:
I've actually picked stuff up from their place in Dayton (section of South Brunswick), maybe a mile or two off of Route 130.
thank you everyone for helping. I will call both places for the weldon cement on monday. South Brunswick is 40mins from my house and ACME is 30mins from my work (dover, nj) and Radiata is 35mins from work.
Radiata, thank you for your offered. I need a lot of Weldon #16 and #3 due to terrible fabricating technique ( I am sux ). instead of use little of cement i have to use more than 2 or 3 times people normally use due to error, redo, try again etc.
thank you again
Olivier
Radiata, thank you for your offered. I need a lot of Weldon #16 and #3 due to terrible fabricating technique ( I am sux
). instead of use little of cement i have to use more than 2 or 3 times people normally use due to error, redo, try again etc.thank you again
Olivier
I haven't been there in a very long time. But the last time I was there they cut sheets to size but it wasn't cheap.
Oliver: I'm in Rockaway and I've got a full tube of 16 you can have. LMK
Oliver: I'm in Rockaway and I've got a full tube of 16 you can have. LMK
Just incase anyone from SNJ is reading this, I recently used E&T Plastics in Mount Laurel for my Weld-on and Sump acrylic. They only charge you by the sheet and do not charge for cuts. They do not have the ability to clean the edge.
I also used Everything Plastic in Philadelphia for some small peices.
I also used Everything Plastic in Philadelphia for some small peices.